camelot-forum.co.uk

Just an update for my Can Comm Fail errors I posted about earlier. Turns out the cable from the can port to the circuit board inside the inverter wasn't connected properly, had to open it up and click it in the rj45 port on the circuit board. After that - all good.

Ah ok, that sounds easy enough - did you have to call up to push the ticket or did they just do it? The couple of us who have raised tickets so far have had no response when just left int he system. Also what are you current DRM and software versions following the push? (or were they just clutching...

Can bus connection is “nice to have” but not “required”, you can set the inverter to lead-acid and adjust the voltages if can-bus cannot work. However I’ve never heard of anyone having the same problems you’re encountering. If it comes to it I'll give that a go although I'm not sure exactly what al...

Hasn't someone posted here about sockets/pins being swapped between different Pylontech models or age versions, but it not being highlighted anywhere? ISTR the solution was to make a bespoke cable with one or two wires swapped to go between the 2 types of batteries. A Yes, pins are swapped now, you...

Welcome :) I don't have my Pylon yet but am expecting a US5000 that's on pre-order - this doesn't bode well however if you're seeing issues with the 3000 which is supposed to be compatible as is :( Just for the benefit of others, what was the process like for Solis updating firmware? Was it over th...

Hello, first time poster but found this board via google. Is there anyone here using this inverter with a Pylontech US3000C which has a serial number with a 'C3' as the 8th and 9th digit? I've just installed this inverter with 2 of these batteries and the can bus connection wont work, I think it mig...