camelot-forum.co.uk

Hi Joe, I must admit it wasn’t easy to remove and I accidentally removed the copper eyelets by mistake. I thought I had done irreversible damage but after some research I learnt that you can replace the eyelets, which I did. At the time I was using a soldering iron to heat the solder and desolderin...

Hi, I don’t have much electronics experience but have successfully managed to replace a few components on my Immersun unit. I’ve attached a couple of photos of the T1 transformer for reference, as you can see it has 6 prongs. The new transformer is on the left and you can see how it compares to the...

Hi Joeirish, You are correct, the T1 transformers used in the Immersun Units were made in Italy. I found it impossible to source a replacement anywhere in the UK and after a lot of research I found the following supplier. The link also gives the part number you need. The price for the unit is the s...

I changed out the T1 transformer as advised by Marcus and I'm back in business, no more error 9 - low voltage. Thanks Marcus. Does anyone know about Solar iBoosts? i have one of those just failed too. Maybe I should start a new thread but it outputs 400 volts when it is supposed to be off and outpu...

I would agree entirely. It’s not easy to identify the exact fault at the moment and I don’t have an in-depth knowledge of electronics, although I’m keen to learn. Im quite happy to leave it as it is and report back if anything changes. By the way I purchased two T1 transformers as they were only €8...

I'm new on this forum but I have a related problem. I started to see an Error 9 Under Voltage message today. The unit had stopped working properly yesterday (not showing an input from the inverter or any export to the grid etc, pic attached) so today I did a factory reset. Then when I selected the h...