Page 1 of 1
Dreaded E031 error again......
Posted: Thu Jun 29, 2023 9:52 pm
by ecogeorge
My original Power one Aurora Pvi 3.6 solar inverter has the dreaded E031 again (repaired seveeral yrs ago) .
Replacement Ginlong fitted today but wish to repair again as a spare.
I can find someone to solder but can't remember where i got the last components,.- anyone got any ideas before i let google search ?
George
Re: Dreaded E031 error again......
Posted: Thu Jun 29, 2023 10:00 pm
by ecogeorge
Save your time -just found on auction site for £2.68 each.
Two have burnt pcb -should I replace all?
George
Re: Dreaded E031 error again......
Posted: Thu Jun 29, 2023 10:04 pm
by ecogeorge
Have also had low internal battery message for several years
- Assume its this one ? If i remove and replace will i lose any data/settings/ ??
George
Re: Dreaded E031 error again......
Posted: Thu Jun 29, 2023 10:28 pm
by ALAN/ALAN D
Have repaired a few over the years.
Its a printed circuit board design fault where the plated through hole / surface area is not big enough to pass the current.
The old relays were taken apart and no signs of internal contact damage were seen.
Before inserting the relay pass multiple copper cables though the two current contact holes. Bend it both sides. Solder a circular cable round the top side. under the relay. Extend the P.C.B. side cables a few mm. in various directions. Insert relay. Solder a nice circular blob over the bits off copper / board track.
Never had on fail after repair.
https://www.rapidonline.com/Zettler-Ele ... gLRBfD_BwE
Re: Dreaded E031 error again......
Posted: Tue Jul 04, 2023 9:34 pm
by ecogeorge
Alan - have sent you 2 x PM's but they show as in outbox ?? when I hover over them they say sent ??
Have you received ?
Sorry to ask publicly but thinking they haven't sent............
George
Re: Dreaded E031 error again......
Posted: Tue Jul 04, 2023 10:23 pm
by ALAN/ALAN D
Hello George
No problem. Can repair and test.
Can you send an Email to
alan.downing@homecall.co.uk
Regards
Alan
Re: Dreaded E031 error again......
Posted: Tue Jul 04, 2023 10:40 pm
by ALAN/ALAN D
The ZETTLER 30 Amp relays by design. ????
Have a very small diameter contact supply cable. The average relay rated at that current
has got connection diameter cable / surface area considerably bigger.
I have been very happy with the AURORA inverters over the years.
I do find it strange it got to production with this type of relay fitted.
I did have one fail on my 6kW wind turbine. That was beyond repair.
The whole printed circuit board caught fire. They stopped selling the 6kW one.