Solar Edge: Monitoring 3rd party battery …

Post Reply
Lincs Robert
Posts: 214
Joined: Fri Mar 11, 2022 7:48 pm
Location: Lincolnshire

Solar Edge: Monitoring 3rd party battery …

#1

Post by Lincs Robert »

Hi,

Ok, so I have 3 Solar Edge inverters and a pair of AC connected LuxPower/Pylon battery banks. On the SE monitoring app, the batteries are essentially invisible with their in/out just being nett of the house consumption- if that makes sense.

In a recent on-line chat with SE about something totally unrelated, I asked if there were any way in which this could be resolved. I got the following reply:

To answer your question , it is possible to monitor the AC battery system by connecting another Modbus meter and set it as “external production”. CT clamps should be facing towards the third-party connections.

I’m seeking further clarification from them as the additional Modbus meter and CT clamp is in the region of £220 - which I’m not adverse to spending if it gives the result I want.

Has anyone else done this, or are people even aware of it? SE requires a metering unit and CT to display house consumption etc on the app - it’s addressable, so the additional (set to a new address) unit would seemingly monitor the AC current into/out of the AC battery system and the rest be done in config/software. It’s essentially what the Myenergi Zappi app does, although that only shows power in/out of the battery at any point in time, but not cumulative totals.

Any comments?

Regards - Rob
Kenny000666
Posts: 78
Joined: Wed Aug 31, 2022 9:16 am

Re: Solar Edge: Monitoring 3rd party battery …

#2

Post by Kenny000666 »

Have you tried directly connecting the inverter via modbus.

I have a super old SE4000 (2015) and recently upgraded the firmware and it had TCP modbus. I previously also looked at their modbus meter but figured no way in hell I was going to for out £200-300 for that.

I followed this doc.
https://www.solaredge.com/sites/default ... l-note.pdf

I can pull all the inverter data via the Ethernet cable (no extra addons purchased). I haven’t tried doing any writes, but I don’t see why writes won’t work. Maybe worth a try before forking out
Kenny000666
Posts: 78
Joined: Wed Aug 31, 2022 9:16 am

Re: Solar Edge: Monitoring 3rd party battery …

#3

Post by Kenny000666 »

Here’s an example of some of the data I am displaying in hass via modbus

Image
Post Reply