camelot-forum.co.uk

I have a Solic immersion diversion controller that work fabuously except that the boost function no longer works . Push button on pcb and it runs at full chat for 90 mins. What has failed is the plastic push button extension that extends to the front cover. Seems a cheap item but where to source ?
Guess could try Solic direct but maybe on the shelf somewhere ?
George

Have you got (or planning to get) a 3D printer as it seems as though that would be a good simple project as a beginner?

Countrypaul wrote: ↑Sun Apr 14, 2024 11:02 pm Have you got (or planning to get) a 3D printer as it seems as though that would be a good simple project as a beginner?

Pah .......3d printing ??????????? struggle to get DAB radio to work .........Nothing wrong with long wave....
Will contact Solic but think its an off the shelf item......
George.

I’d be looking at modifying a plastic knitting needle George. Some are fat, perhaps over 1/4”.

This is my Solic 200 which has a green push button.

Air dried modelling clay?

AGT wrote: ↑Mon Apr 15, 2024 10:43 am Air dried modelling clay?

Or Sugru.

Stan wrote: ↑Mon Apr 15, 2024 10:39 am

This is my Solic 200 which has a green push button.

That's a later model -mine is earlier with red but i beleive same size buttons.

If you are able to get measurements, I could 3D print you one.

Thank you for your kind offer , - I may take you up on it and could send a broken one.
I am going to email Solic first -I may be pleasently surprised
George