Pylontech Batteries
Pylontech Batteries
Interested if anyone has any real life experience of installing/using these, especially off grid. Considering replacing my existing FLA battery bank, but undecided which way to go.
Off Grid home
3.5kW PV panels 2kW wind turbine
Solar thermal tubes 2500L thermal store
Perge log boiler
6 x Pylontech batteries
9kVa Lister generator
3.5kW PV panels 2kW wind turbine
Solar thermal tubes 2500L thermal store
Perge log boiler
6 x Pylontech batteries
9kVa Lister generator
Re: Pylontech Batteries
I think there are at least 5 of us here who have Pylontechs(could be more, I lost my list)! No complaints that I remember on them. 48V ststem, nice and simple, I run US2000b's mostly. Always worth hunting around as prices vary quite a bit, not sure there will be or is an Evergreen ripple? Some run with a bms, some without.
There are also US2000c's out which discharge to 95% but they are quite pricey what with being new. The b's will discharge to 90%. The bigger the bank the less stress on the stack overall.
Zero maintenance and no gassing off so opens up further siting options.
3 years in and my stack of 6 has a SOH of 97%, set to discharge 90% SOC. You can set this lower and extend stack life, i'll just see how it plays out.
There are also US2000c's out which discharge to 95% but they are quite pricey what with being new. The b's will discharge to 90%. The bigger the bank the less stress on the stack overall.
Zero maintenance and no gassing off so opens up further siting options.
3 years in and my stack of 6 has a SOH of 97%, set to discharge 90% SOC. You can set this lower and extend stack life, i'll just see how it plays out.
19.7kW PV SE, VI, HM, EN & DW
Ripple 7kW WT & Gen to date 19MWh
42kWh LFPO4 storage
95kWh Heater storage
12kWh 210ltr HWT.
73kWh HI5
Deep insulation, air leak ct'd home
Zoned GCH & Hive 2
WBSx2
Low energy bulbs
Veg patches & fruit trees
Ripple 7kW WT & Gen to date 19MWh
42kWh LFPO4 storage
95kWh Heater storage
12kWh 210ltr HWT.
73kWh HI5
Deep insulation, air leak ct'd home
Zoned GCH & Hive 2
WBSx2
Low energy bulbs
Veg patches & fruit trees
Re: Pylontech Batteries
@DaveB275, shame the old forum is dead and buried as there were many threads with so much info on such things. There were some die hard FLA fans with decades of experience with them who were suspicious or dismissive of lithium technology, especially 5 or more years ago. But I think the tide is or has changed somewhat. Especially with the evidence now from the use of them in electric cars.
I am one of the few who have had both types of technology and for me there is no contest.
I am ongrid, but did use a second offgrid system with FLA (forklift cells) for 6 years, then I integrated some growatt lithium cells to work in parallel with the lead acid. Long story but in the end it became evident that lithium was just so much better in so many ways (apart from cost). More efficient, longer life, no noxious explosive gasses, no need to top up with water, can leave for months at any SOC, accepts massive amounts of amps practically to full, no need for long absorption charge or any need for EQ charging.
I have roughly three 20kWh battery banks in parallel. Two are re-used growatt lithium which I re-engineered and cost similar to FLA but has been a lot of work to achieve my final working configuration. A summary of the work can be found here,
viewtopic.php?f=15&t=67
But the other bank is 8 x 2.4kWh Pylontech batteries.
They have been in use for about 4.5 years, not much to say about them other than they just work without any maintenance and are still as good as new.
If you want to go down the lithium path, you have two choices,
1) Build up your own pack with new cells, the price has now dropped to the point of being able to buy new cells at roughly £150 per kWh, but extra costs for cell balancers, etc so you will end up with circa £200 per kWh.
2) Buy something like Pylontechs for about £250 per kWh, but everything works out of the box with a 10 year warranty and being modular, if you have a failure, you just swap the failed unit out.
So, unless you like playing and tinkering with stuff, the Pylontech batteries are a no brainer. The only limitation is the 25mm cable size so is limited to about 100 Amps, unless you parallel up several banks like I do and run a larger cable to the inverter.
I am one of the few who have had both types of technology and for me there is no contest.
I am ongrid, but did use a second offgrid system with FLA (forklift cells) for 6 years, then I integrated some growatt lithium cells to work in parallel with the lead acid. Long story but in the end it became evident that lithium was just so much better in so many ways (apart from cost). More efficient, longer life, no noxious explosive gasses, no need to top up with water, can leave for months at any SOC, accepts massive amounts of amps practically to full, no need for long absorption charge or any need for EQ charging.
I have roughly three 20kWh battery banks in parallel. Two are re-used growatt lithium which I re-engineered and cost similar to FLA but has been a lot of work to achieve my final working configuration. A summary of the work can be found here,
viewtopic.php?f=15&t=67
But the other bank is 8 x 2.4kWh Pylontech batteries.
They have been in use for about 4.5 years, not much to say about them other than they just work without any maintenance and are still as good as new.
If you want to go down the lithium path, you have two choices,
1) Build up your own pack with new cells, the price has now dropped to the point of being able to buy new cells at roughly £150 per kWh, but extra costs for cell balancers, etc so you will end up with circa £200 per kWh.
2) Buy something like Pylontechs for about £250 per kWh, but everything works out of the box with a 10 year warranty and being modular, if you have a failure, you just swap the failed unit out.
So, unless you like playing and tinkering with stuff, the Pylontech batteries are a no brainer. The only limitation is the 25mm cable size so is limited to about 100 Amps, unless you parallel up several banks like I do and run a larger cable to the inverter.
18.7kW PV > 109MWh generated
Ripple 6.6kW Wind + 4.5kW PV > 26MWh generated
5 Other RE Coop's
105kWh EV storage
60kWh Home battery storage
40kWh Thermal storage
GSHP + A2A HP's
Rain water use > 510 m3
Ripple 6.6kW Wind + 4.5kW PV > 26MWh generated
5 Other RE Coop's
105kWh EV storage
60kWh Home battery storage
40kWh Thermal storage
GSHP + A2A HP's
Rain water use > 510 m3
Re: Pylontech Batteries
When looking at batteries I found this study very informative:
https://batterytestcentre.com.au/wp-con ... ch2021.pdf
They compare various batteries by cycling them 24/7/365. The Pylontechs compare favourably to other batteries on reliability and capacity retained after thousands of cycles.
https://batterytestcentre.com.au/wp-con ... ch2021.pdf
They compare various batteries by cycling them 24/7/365. The Pylontechs compare favourably to other batteries on reliability and capacity retained after thousands of cycles.
12x 340W JA Solar panels (4.08kWp)
3x 380W JA Solar panels (1.14kWp)
5x 2.4kWh Pylontech batteries (12kWh)
LuxPower inverter/charger
(Artist formally known as ******, well it should be obvious enough to those for whom such things are important.)
3x 380W JA Solar panels (1.14kWp)
5x 2.4kWh Pylontech batteries (12kWh)
LuxPower inverter/charger
(Artist formally known as ******, well it should be obvious enough to those for whom such things are important.)
Re: Pylontech Batteries
Thanks everyone for the replies. That's exactly what I hoped for - real life experience.
I'm very tempted to make the switch to lithium, but my only problem is my entire system is 24V, and finding 24V Pylontech units in the UK is like looking for unicorn poo. They seem to be more common in Spain and Italy, but of course then there's import duty etc.
I'm very tempted to make the switch to lithium, but my only problem is my entire system is 24V, and finding 24V Pylontech units in the UK is like looking for unicorn poo. They seem to be more common in Spain and Italy, but of course then there's import duty etc.
Off Grid home
3.5kW PV panels 2kW wind turbine
Solar thermal tubes 2500L thermal store
Perge log boiler
6 x Pylontech batteries
9kVa Lister generator
3.5kW PV panels 2kW wind turbine
Solar thermal tubes 2500L thermal store
Perge log boiler
6 x Pylontech batteries
9kVa Lister generator
Re: Pylontech Batteries
I feel some Déjà vu here, I think we had almost the same chat on one of the other forums, whether it was the n one or the a one, I cannot remember. But yes, good to re-visit the argument and yes 24v ones exist in other countries in Europe, but never seen them available in the UK.DavB275 wrote: ↑Sun Jul 11, 2021 6:06 pm Thanks everyone for the replies. That's exactly what I hoped for - real life experience.
I'm very tempted to make the switch to lithium, but my only problem is my entire system is 24V, and finding 24V Pylontech units in the UK is like looking for unicorn poo. They seem to be more common in Spain and Italy, but of course then there's import duty etc.
18.7kW PV > 109MWh generated
Ripple 6.6kW Wind + 4.5kW PV > 26MWh generated
5 Other RE Coop's
105kWh EV storage
60kWh Home battery storage
40kWh Thermal storage
GSHP + A2A HP's
Rain water use > 510 m3
Ripple 6.6kW Wind + 4.5kW PV > 26MWh generated
5 Other RE Coop's
105kWh EV storage
60kWh Home battery storage
40kWh Thermal storage
GSHP + A2A HP's
Rain water use > 510 m3
Re: Pylontech Batteries
Oh!!
I've just taken the plunge and ordered 15 US3000C, delivery won't be until the end of September, just ready for winter and hopefully a smart meter by then.
I've just taken the plunge and ordered 15 US3000C, delivery won't be until the end of September, just ready for winter and hopefully a smart meter by then.
Last edited by Tinbum on Thu Jul 15, 2021 4:46 pm, edited 1 time in total.
85no 58mm solar thermal tubes, 28.5Kw PV, 3x Sunny Island 5048, 2795 Ah (135kWh) (c20) Rolls batteries 48v, 8kWh Growatt storage, 22 x US3000C Pylontech, Sofar ME3000's, Brosley wood burner and 250lt DHW
Re: Pylontech Batteries
I assume you mean US3000C ?
That would make a tasty battery array! What inverter are you using with them?
That would make a tasty battery array! What inverter are you using with them?
12x 340W JA Solar panels (4.08kWp)
3x 380W JA Solar panels (1.14kWp)
5x 2.4kWh Pylontech batteries (12kWh)
LuxPower inverter/charger
(Artist formally known as ******, well it should be obvious enough to those for whom such things are important.)
3x 380W JA Solar panels (1.14kWp)
5x 2.4kWh Pylontech batteries (12kWh)
LuxPower inverter/charger
(Artist formally known as ******, well it should be obvious enough to those for whom such things are important.)
Re: Pylontech Batteries
15!!! What, like 10+5 type 15? Bloody hell, well done!
19.7kW PV SE, VI, HM, EN & DW
Ripple 7kW WT & Gen to date 19MWh
42kWh LFPO4 storage
95kWh Heater storage
12kWh 210ltr HWT.
73kWh HI5
Deep insulation, air leak ct'd home
Zoned GCH & Hive 2
WBSx2
Low energy bulbs
Veg patches & fruit trees
Ripple 7kW WT & Gen to date 19MWh
42kWh LFPO4 storage
95kWh Heater storage
12kWh 210ltr HWT.
73kWh HI5
Deep insulation, air leak ct'd home
Zoned GCH & Hive 2
WBSx2
Low energy bulbs
Veg patches & fruit trees
Re: Pylontech Batteries
Yes sorry, corrected.
My old faithful SMA Sunny Island 5048s. As we are 3 phase I will do 3 banks of 5 and then paralleled up.
85no 58mm solar thermal tubes, 28.5Kw PV, 3x Sunny Island 5048, 2795 Ah (135kWh) (c20) Rolls batteries 48v, 8kWh Growatt storage, 22 x US3000C Pylontech, Sofar ME3000's, Brosley wood burner and 250lt DHW