Lister generator

Deanforest
Posts: 3
Joined: Tue Nov 08, 2022 11:29 am

Lister generator

#1

Post by Deanforest »

Hi there. I have a lot of experience with SR and ST lister engines over the years and currently have an SR1 running a 3kw lister generator which is backup for our off grid solar battery bank. But currently needing to make an alteration to the generator itself. The current voltage output is about 222 volts, but at full load (10amps), there is a voltage drop of about 4 volts over the 100 metres between generator and house. There’s a good thick copper cable of around 20 mm sq installed. This has never been a problem till now we have another washing machine which goes into fault mode at less than 220 volts. I am trying to find out how to increase the voltage output on the generator. Washing machine runs fine on battery/inverter at 230 volts which is what I have set the inverter to. My immediate feeling is that I need to increase the field current, but I may be wrong. It’s a shunt wound generator by the look of it and the unit has a double slipping. The whole unit is from 1962, had been little used on emergency standby.
The actual generator is a Brush, model SCAF1, with the 12 volt starting coil integral in the generator, so the generator itself runs on 12 volts to start the engine. I have a quite comprehensive manual for it which states it is a 220/240 volt generator with 13 amp output, but it doesn’t give me the info I need. Can any lister expert out there help on this one?
Oldgreybeard
Posts: 1873
Joined: Thu Sep 09, 2021 3:42 pm
Location: North East Dorset

Re: Lister generator

#2

Post by Oldgreybeard »

I used to have a similar generator some years ago and my recollection was that the output voltage was tied to the engine RPM, so if it was a bit low then the governor needed to be adjusted to increase it. Doing this also increased the frequency slightly, but these things were often not too precise at delivering 50Hz anyway, as they have very simplistic controls. I don't remember the one I had having any sort of AVR, everything was mechanical.

Probably worth having a go at increasing the engine RPM slightly, as I think that may well solve your problem. Unfortunately I gave away all the old manuals I had when I got rid of the generator, years ago, and I can't remember exactly how to adjust the governor, but do remember mine getting a bit sticky, resulting in the RPM slowing down a bit.

The other thing I remember fixing on mine was the selenium rectifier that drives the field windings. These have a habit of gradually failing, and may also be the cause of the lower voltage you're seeing. There used to be a replacement rectifier for the older selenium ones, made as an after market repair kit. Not sure if they are still available, but might also be worth looking at.
25 off 250W Perlight solar panels, installed 2014, with a 6kW PowerOne inverter, about 6,000kWh/year generated
6 off Pylontech US3000C batteries, with a Sofar ME3000SP inverter
openspaceman
Posts: 662
Joined: Mon Mar 21, 2022 7:37 pm

Re: Lister generator

#3

Post by openspaceman »

Why not run the generator into a charger and feed the battery directly when the washing machine is running? Okay there is a loss but much less fiddling than trying to get a vintage genset up to the job.
Morso S11
FIT
16 Sharp PV panels facing WSW 4kW
Solarmax 4200S inverter
Non FIT
3 Canadian solar DC coupled 1.75kW facing SSE
Storage
Growatt SPA3000TL BL inverter ac coupled
Growatt GBLI6532 6.5kWh lithium phosphate battery
Oldgreybeard
Posts: 1873
Joined: Thu Sep 09, 2021 3:42 pm
Location: North East Dorset

Re: Lister generator

#4

Post by Oldgreybeard »

I think there is a good argument to keep these older generators going, largely because the Lister/Petter engines are absolutely bomb proof and will run for decades, plus the fact that I think it's better to re-use/recycle than buy new and throw out something that can still be used.

I regret getting rid of mine, as the small petrol genset I replaced it with is a pile of crap in comparison. One big advantage with these older generators is that they are pretty much infinitely repairable, without the need for electronic parts that may cease to be available at some point.
25 off 250W Perlight solar panels, installed 2014, with a 6kW PowerOne inverter, about 6,000kWh/year generated
6 off Pylontech US3000C batteries, with a Sofar ME3000SP inverter
openspaceman
Posts: 662
Joined: Mon Mar 21, 2022 7:37 pm

Re: Lister generator

#5

Post by openspaceman »

That's a non sequitur young man; I wasn't suggesting not using the old genset, I have a rake of old machinery one of which which I have kept going for over 48 years and the other five are not far behind, indeed I even have the rusty hulk that was my wife's twenty first birthday present that I have just replaced the disintegrated distributor in.

Anyway my question was not entirely rhetorical. What would a simple charger cost to keep the battery topped up while the washing machine is running?

I wonder if I put a rectified 110V supply with a big capacitor bank across it whether my MPPT charger would work on a cloudy day.
Morso S11
FIT
16 Sharp PV panels facing WSW 4kW
Solarmax 4200S inverter
Non FIT
3 Canadian solar DC coupled 1.75kW facing SSE
Storage
Growatt SPA3000TL BL inverter ac coupled
Growatt GBLI6532 6.5kWh lithium phosphate battery
Marcus
Posts: 270
Joined: Mon Nov 08, 2021 6:25 pm

Re: Lister generator

#6

Post by Marcus »

I'm confused - how does charging a battery keep the generator voltage above 220v?
450W hydro-electric
5110W pv
1.3kw Wt2 - not yet producing
6kWh lead acid - maybe 1kwh useable
LiMnCo battery made from 2nd hand hybrid car modules 3.6kwh nominal 24v.
300lt hot water tank and two storage heaters
ASHP Grant Aerona 3 10.5kw and UFH
ALAN/ALAN D

Re: Lister generator

#7

Post by ALAN/ALAN D »

Post from. “ Mr Marcus “

“I'm confused - how does charging a battery keep the generator voltage above 220v?”


It does not keep the generator voltage above 220v.


But as “ Mr Openspacemann “ said.

“Why not run the generator into a charger and feed the battery directly when the washing machine is running? “

Mr “ Deanforest “

Said. “ Washing machine runs fine on battery/inverter at 230 volts which is what I have set the inverter to. “

If the generator cant be fixed. The washing can be done by charging the battery with the generator running a battery charger.
Oldgreybeard
Posts: 1873
Joined: Thu Sep 09, 2021 3:42 pm
Location: North East Dorset

Re: Lister generator

#8

Post by Oldgreybeard »

I'm near-certain there is a fairly easy fix that will get this generator back up to voltage. These are really simple machines, they have no electronics or complex controls and rely on the engine running at the right speed to deliver the set output voltage, IIRC. They do this with a pretty simple RPM governor, that compensates for changes in load by changing the "throttle" setting (in reality it moves the fuel pump rack).

The other common cause of low voltage is when the selenium rectifier starts to fail. These fail gradually, over a period of years, but there used to be a replacement kit available, and in all probability it should be easy enough to swap a failing selenium rectifier for a modern silicon one. As the voltage is only a bit low, my money is on the governor needing adjustment or servicing.
25 off 250W Perlight solar panels, installed 2014, with a 6kW PowerOne inverter, about 6,000kWh/year generated
6 off Pylontech US3000C batteries, with a Sofar ME3000SP inverter
AGT
Posts: 996
Joined: Sat Jan 29, 2022 11:26 am

Re: Lister generator

#9

Post by AGT »

Ken Boak/ power cubes used to run his lister and export the power to the house, he had underground insulted pipe work and connected the generator water tank to his central heating system.

Great days of watching that happen.
Oldgreybeard
Posts: 1873
Joined: Thu Sep 09, 2021 3:42 pm
Location: North East Dorset

Re: Lister generator

#10

Post by Oldgreybeard »

AGT wrote: Wed Nov 09, 2022 8:56 am Ken Boak/ power cubes used to run his lister and export the power to the house, he had underground insulted pipe work and connected the generator water tank to his central heating system.

Great days of watching that happen.
Always wanted to do something similar, even went so far as to try and import an Indian made "Listeroid" CS engine a few years ago. Got scuppered by SWMBO, who didn't like the idea of having something like this thumping away in a shed in the garden.
25 off 250W Perlight solar panels, installed 2014, with a 6kW PowerOne inverter, about 6,000kWh/year generated
6 off Pylontech US3000C batteries, with a Sofar ME3000SP inverter
Post Reply