Hi all, i have not been on a UK forum for some time.
-
- Posts: 132
- Joined: Sat Dec 04, 2021 11:04 am
- Location: Normandy, France.
- Contact:
Hi all, i have not been on a UK forum for some time.
Nice to see some old names on this new Forum.
I promise not to upset anyone!
Yes still at it out here in France, its over 20 years now.
Out of 12 buildings here just 2 left for re-build to passive house standards etc.
Never have enough renewable energy.
I promise not to upset anyone!
Yes still at it out here in France, its over 20 years now.
Out of 12 buildings here just 2 left for re-build to passive house standards etc.
Never have enough renewable energy.
Re: Hi all, i have not been on a UK forum for some time.
Welcome onboard!
19.7kW PV SE, VI, HM, EN & DW
Ripple 7kW WT & Gen to date 19MWh
42kWh LFPO4 storage
95kWh Heater storage
12kWh 210ltr HWT.
73kWh HI5
Deep insulation, air leak ct'd home
Zoned GCH & Hive 2
WBSx2
Low energy bulbs
Veg patches & fruit trees
Ripple 7kW WT & Gen to date 19MWh
42kWh LFPO4 storage
95kWh Heater storage
12kWh 210ltr HWT.
73kWh HI5
Deep insulation, air leak ct'd home
Zoned GCH & Hive 2
WBSx2
Low energy bulbs
Veg patches & fruit trees
Re: Hi all, i have not been on a UK forum for some time.
Hello matey, nice to see you again.
8.7kWp PV [2.12kWp SSW + 4.61kWp ESE PV + 2.0kWp WNW PV]
Two BEV's.
Two small A2A heatpumps.
20kWh Battery storage.
Two BEV's.
Two small A2A heatpumps.
20kWh Battery storage.
Re: Hi all, i have not been on a UK forum for some time.
Ditto- I used to enjoy your threads.
85no 58mm solar thermal tubes, 28.5Kw PV, 3x Sunny Island 5048, 2795 Ah (135kWh) (c20) Rolls batteries 48v, 8kWh Growatt storage, 22 x US3000C Pylontech, Sofar ME3000's, Brosley wood burner and 250lt DHW
Re: Hi all, i have not been on a UK forum for some time.
Hi Clockman, good to hear from you again, remember and keep us updated on your ongoing renovations, wind turbine maintenance/repair, etc.
3.87kWp PV
10.24kWp PV SolarEdge system
Tesla Powerwall 2
100 x 47mm Navitron tubes (still being installed!) Now likely to be removed for more PV.
MK2 PV router DHW diverter
Morso 5kW WBS
Vaillant AroTherm 10kW ASHP
Nissan Leaf
10.24kWp PV SolarEdge system
Tesla Powerwall 2
100 x 47mm Navitron tubes (still being installed!) Now likely to be removed for more PV.
MK2 PV router DHW diverter
Morso 5kW WBS
Vaillant AroTherm 10kW ASHP
Nissan Leaf
Re: Hi all, i have not been on a UK forum for some time.
Long term installed renewables are as much interest as new kit, (with a lot more data & living experience).
As well as comparing (in renovations) "how you did it last time compared to how you upped the ante"
Welcome back
As well as comparing (in renovations) "how you did it last time compared to how you upped the ante"
Welcome back
1906 ripplewatts @wind Turb-ine-erry
It's the wifes Tesla 3 (she lets me wash it)
Leaf 24
Celotex type insulation stuffed most places
Skip diver to the gentry
Austroflamm WBS
A finger of solar + shed full more
It's the wifes Tesla 3 (she lets me wash it)
Leaf 24
Celotex type insulation stuffed most places
Skip diver to the gentry
Austroflamm WBS
A finger of solar + shed full more
Re: Hi all, i have not been on a UK forum for some time.
Hi Clockman. Is that tracker still tracking?
Re: Hi all, i have not been on a UK forum for some time.
I'd love to see a revisit of the tracker installation!
Nowty has reshared his stream-under-house lemonade-out-of-lemons heatpump project. Something similar about your tracker would be amazing!
Nowty has reshared his stream-under-house lemonade-out-of-lemons heatpump project. Something similar about your tracker would be amazing!
12x 340W JA Solar panels (4.08kWp)
3x 380W JA Solar panels (1.14kWp)
5x 2.4kWh Pylontech batteries (12kWh)
LuxPower inverter/charger
(Artist formally known as ******, well it should be obvious enough to those for whom such things are important.)
3x 380W JA Solar panels (1.14kWp)
5x 2.4kWh Pylontech batteries (12kWh)
LuxPower inverter/charger
(Artist formally known as ******, well it should be obvious enough to those for whom such things are important.)
Re: Hi all, i have not been on a UK forum for some time.
Nice to see you here too .........
George
1750w Vertical PV micro inverters
3800w almost horizontal/south
Aarrow Becton 7 Woodburner
Dream 3kw ASHP only connected to summer Pool.
Allotment heavy clay.
1.784kw Kirk Hill
0.875kw Derril Water
0.2kwWhitelaw Brae
1kw Harlow Hydro.
3800w almost horizontal/south
Aarrow Becton 7 Woodburner
Dream 3kw ASHP only connected to summer Pool.
Allotment heavy clay.
1.784kw Kirk Hill
0.875kw Derril Water
0.2kwWhitelaw Brae
1kw Harlow Hydro.
-
- Posts: 132
- Joined: Sat Dec 04, 2021 11:04 am
- Location: Normandy, France.
- Contact:
Re: Hi all, i have not been on a UK forum for some time.
Thank you so much for the Welcome.
Thanks to, Joeboy, Mart, Tinbum, Fintray, Mr Gus, Stan, Stinsy and ecoGeorge.
As most of you are aware i spent most of my time nowadays posting on USA forum 'Fieldlines' and the Australian 'Backshed'. Where the forum moderators are very supportive of what and where we are going.
Trackers are all behaving, although last year i change 2 of the LED East to West circuits and sensors and fitted 'RedRock' USA simple circuits that work very well and use 2 FET's and drive direct my actuators, ie no flipping relays. They operate every 5 minutes or so and operate the actuators for just 2 seconds each time, so energy use is very minimum. My friend in Australia 'Dave' is no longer suppling his simple circuits, as he is very unwell.
However i no longer recommend Solar trackers, as the gain is only 20% to 30% more than array of the same output. My trackers can only take 8 panels so about 2.8kW so on my arrays just another 2off Trini or Longi monos for about £230 is cheaper than making a tracker.
All 3 3.7m wind turbines all still functioning, but some FAKE so called Marine Ply on the blade assembly hubs has meant 2 off have had rebuilds with new ally hub discs.
OzInverter's still operating around the World, and mine still 24/7. I do have a 8kW ready for installation but to be honest my 6kW design does everything i want, plus AC coupling is so simple with a bi-directional OzInverter.
Doing R&D and building 2v 550ah lead acid PLANTE batteries at present.
Lots of other projects also happening, and i will let you all know what's going on here.
We have 19kW of PV up, aiming for 30kW, and just the Trackers are direct DC to MPPT controllers, all other PV is AC Coupled to our OzInverter created Mini Grid.
A few years ago installed a 12m by 4.5m with roman steps, fiberglass Salt swimming pool, which has Air source Pump heating and runs off our own created Renewable Energy.
Getting masses of enquiries from the general public about or Project here, so now finishing the Sheep Grange Lecture Theatre, so perhaps in a few years time we can do group lectures/courses.
Any ways lots of things to tell you all one day.
Here is a selfie, my first ever selfie, from last summer, yep pool is a nice 33c.
Thanks to, Joeboy, Mart, Tinbum, Fintray, Mr Gus, Stan, Stinsy and ecoGeorge.
As most of you are aware i spent most of my time nowadays posting on USA forum 'Fieldlines' and the Australian 'Backshed'. Where the forum moderators are very supportive of what and where we are going.
Trackers are all behaving, although last year i change 2 of the LED East to West circuits and sensors and fitted 'RedRock' USA simple circuits that work very well and use 2 FET's and drive direct my actuators, ie no flipping relays. They operate every 5 minutes or so and operate the actuators for just 2 seconds each time, so energy use is very minimum. My friend in Australia 'Dave' is no longer suppling his simple circuits, as he is very unwell.
However i no longer recommend Solar trackers, as the gain is only 20% to 30% more than array of the same output. My trackers can only take 8 panels so about 2.8kW so on my arrays just another 2off Trini or Longi monos for about £230 is cheaper than making a tracker.
All 3 3.7m wind turbines all still functioning, but some FAKE so called Marine Ply on the blade assembly hubs has meant 2 off have had rebuilds with new ally hub discs.
OzInverter's still operating around the World, and mine still 24/7. I do have a 8kW ready for installation but to be honest my 6kW design does everything i want, plus AC coupling is so simple with a bi-directional OzInverter.
Doing R&D and building 2v 550ah lead acid PLANTE batteries at present.
Lots of other projects also happening, and i will let you all know what's going on here.
We have 19kW of PV up, aiming for 30kW, and just the Trackers are direct DC to MPPT controllers, all other PV is AC Coupled to our OzInverter created Mini Grid.
A few years ago installed a 12m by 4.5m with roman steps, fiberglass Salt swimming pool, which has Air source Pump heating and runs off our own created Renewable Energy.
Getting masses of enquiries from the general public about or Project here, so now finishing the Sheep Grange Lecture Theatre, so perhaps in a few years time we can do group lectures/courses.
Any ways lots of things to tell you all one day.
Here is a selfie, my first ever selfie, from last summer, yep pool is a nice 33c.