Solic diversion controller repair

[ecogeorge]

I have a Solic immersion diversion controller that work fabuously except that the boost function no longer works . Push button on pcb and it runs at full chat for 90 mins. What has failed is the plastic push button extension that extends to the front cover. Seems a cheap item but where to source ?
Guess could try Solic direct but maybe on the shelf somewhere ?
George

[Countrypaul]

Have you got (or planning to get) a 3D printer as it seems as though that would be a good simple project as a beginner?

[ecogeorge]

Have you got (or planning to get) a 3D printer as it seems as though that would be a good simple project as a beginner?

Pah .......3d printing ??????????? struggle to get DAB radio to work .........Nothing wrong with long wave....
Will contact Solic but think its an off the shelf item......
George.

[Stan]

I’d be looking at modifying a plastic knitting needle George. Some are fat, perhaps over 1/4”.

[Stan]

This is my Solic 200 which has a green push button.

[AGT]

Air dried modelling clay?

[Fintray]

Air dried modelling clay?

Or Sugru.

[ecogeorge]

This is my Solic 200 which has a green push button.

That's a later model -mine is earlier with red but i beleive same size buttons.

[smegal]

If you are able to get measurements, I could 3D print you one.

[ecogeorge]

Thank you for your kind offer , - I may take you up on it and could send a broken one.
I am going to email Solic first -I may be pleasently surprised
George