Plus insert a length of welding rod or similar inside the tube to create a rigid section over the joint.
Joining cable
Re: Joining cable
as above, adhesive heat shrink - I like the welding rod
but also.... layer up the heat shrink, 3 or 4 layers, and make then longer than needed... each bit 2inch longer than the bit under it
if it got bashed/broken somehow and needs protection, sleeve it inside a bit of water pipe? a roll of 15mm pex tubing is cheap enough
but also.... layer up the heat shrink, 3 or 4 layers, and make then longer than needed... each bit 2inch longer than the bit under it
if it got bashed/broken somehow and needs protection, sleeve it inside a bit of water pipe? a roll of 15mm pex tubing is cheap enough
-
- Posts: 2285
- Joined: Wed Jun 02, 2021 6:10 pm
Re: Joining cable
I don't - not if it's like a "stick" welding rod...
The coatings are horribly corrosive if they get damp and should never be held in the hand for any length of time. They are full of fluorides and other nasty stuff designed to instantly etch the surfaces you are welding as well as make a protective oxygen-excluding cloud.
Almost any stiff wire or plastic rod would be better as long as it didn't have sharp ends which could chafe the insulation on the conductors.
2.0 kW/4.62 MWh pa in Ripples, 4.5 kWp W-facing pv, 9.5 kWh Givenergy batt
30 solar thermal tubes, 2MWh pa in Stockport, plus Congleton and Kinlochbervie Hydros,
Most travel by bike, walking or bus/train. Veg, fruit - and Bees!
30 solar thermal tubes, 2MWh pa in Stockport, plus Congleton and Kinlochbervie Hydros,
Most travel by bike, walking or bus/train. Veg, fruit - and Bees!
Re: Joining cable
good point, my brain automatically went to tig rod without giving it much thought!
could always bash the flux of a stick welder rod?
could always bash the flux of a stick welder rod?
Re: Joining cable
Plain uncoated Gas Welding rod or Brazing Rod, anything to add stiffness.
Re: Joining cable
Can’t see a welding rod or similar used in any manufacturers instructions for joining cables….
Re: Joining cable
If it's something that is ever replaced, a non permanent solution will be of value to whoever works on them. Wagos in a junction box. Or run a length of conduit box with removable cover the length of the parlour and put all joints there.
If it's just to lengthen the cables a bit to get them to where they are terminated, in this exact same scenario, (different milk meters though) I solder individual cables and heat shrink them individually. Then cover the lot in one or two layers of heat shrink.
If it's just to lengthen the cables a bit to get them to where they are terminated, in this exact same scenario, (different milk meters though) I solder individual cables and heat shrink them individually. Then cover the lot in one or two layers of heat shrink.
5kW Evance WT
3x 4kW PV arrays
Lots of diverters and thermal storage.
Business side;
40kW PV
Heat recovery on refrigeration plant
More diverters here for hot water.
3x 4kW PV arrays
Lots of diverters and thermal storage.
Business side;
40kW PV
Heat recovery on refrigeration plant
More diverters here for hot water.