Hello from Somerset
Hello from Somerset
Hi,
I’ve stumbled across here after following energy related threads on other forums. I’m hoping to pick up ideas and advise to improve my home energy system. Having a old, leaky, poorly insulated house I will need all the help I can get to reduce oil consumption with a mixed strategy of wood and renewables.
Im 18th edition qualified with a small DIY solar install on my garage/home office roof. For work I install and build emergency power systems including large batteries so hopefully I can give some useful input back into the forum.
All the best, Jinx
I’ve stumbled across here after following energy related threads on other forums. I’m hoping to pick up ideas and advise to improve my home energy system. Having a old, leaky, poorly insulated house I will need all the help I can get to reduce oil consumption with a mixed strategy of wood and renewables.
Im 18th edition qualified with a small DIY solar install on my garage/home office roof. For work I install and build emergency power systems including large batteries so hopefully I can give some useful input back into the forum.
All the best, Jinx
Re: Hello from Somerset
Welcome Jinx!
The mantra is insulate, insulate, insulate. Only caveat being to allow airflow through to wick the moisture away.
The mantra is insulate, insulate, insulate. Only caveat being to allow airflow through to wick the moisture away.
19.7kW PV SE, VI, HM, EN & DW
Ripple 7kW WT & Gen to date 19MWh
42kWh LFPO4 storage
95kWh Heater storage
12kWh 210ltr HWT.
73kWh HI5
Deep insulation, air leak ct'd home
Zoned GCH & Hive 2
WBSx2
Low energy bulbs
Veg patches & fruit trees
Ripple 7kW WT & Gen to date 19MWh
42kWh LFPO4 storage
95kWh Heater storage
12kWh 210ltr HWT.
73kWh HI5
Deep insulation, air leak ct'd home
Zoned GCH & Hive 2
WBSx2
Low energy bulbs
Veg patches & fruit trees
Re: Hello from Somerset
Bonjourno, salut, & willkommen jinx.
(& Now the Icelandic entry)
(& Now the Icelandic entry)
1906 ripplewatts @wind Turb-ine-erry
It's the wifes Tesla 3 (she lets me wash it)
Leaf 24
Celotex type insulation stuffed most places
Skip diver to the gentry
Austroflamm WBS
A finger of solar + shed full more
It's the wifes Tesla 3 (she lets me wash it)
Leaf 24
Celotex type insulation stuffed most places
Skip diver to the gentry
Austroflamm WBS
A finger of solar + shed full more
Re: Hello from Somerset
Thank you gents.
Insulating is an issue, it’s a 1920s brick built detached in an exposed location, to do it properly would probably take me close to a full rebuild budget wise. I can do stuff that will help either way as there is land for ground source and outbuildings for more solar.
Insulating is an issue, it’s a 1920s brick built detached in an exposed location, to do it properly would probably take me close to a full rebuild budget wise. I can do stuff that will help either way as there is land for ground source and outbuildings for more solar.
-
- Posts: 662
- Joined: Mon Mar 21, 2022 7:37 pm
Re: Hello from Somerset
Wow I'm looking forward to your input on that Jinx, I'm virtually totally wood heated but hoping to get into a bit of chp, initially with lpg, to my mind a solar pv and storage battery lend themselves to being charged at constant power for just a few hours per day in winter.Jinx wrote: ↑Wed Sep 21, 2022 8:47 pm Hi,
I’ve stumbled across here after following energy related threads on other forums. I’m hoping to pick up ideas and advise to improve my home energy system. Having a old, leaky, poorly insulated house I will need all the help I can get to reduce oil consumption with a mixed strategy of wood and renewables.
Im 18th edition qualified with a small DIY solar install on my garage/home office roof. For work I install and build emergency power systems including large batteries so hopefully I can give some useful input back into the forum.
All the best, Jinx
Morso S11
FIT
16 Sharp PV panels facing WSW 4kW
Solarmax 4200S inverter
Non FIT
3 Canadian solar DC coupled 1.75kW facing SSE
Storage
Growatt SPA3000TL BL inverter ac coupled
Growatt GBLI6532 6.5kWh lithium phosphate battery
FIT
16 Sharp PV panels facing WSW 4kW
Solarmax 4200S inverter
Non FIT
3 Canadian solar DC coupled 1.75kW facing SSE
Storage
Growatt SPA3000TL BL inverter ac coupled
Growatt GBLI6532 6.5kWh lithium phosphate battery
Re: Hello from Somerset
There are so many levels to insulating a property. From a weather strip on the front door all the way through to a teardown and rebuild as a passivhaus.Jinx wrote: ↑Wed Sep 21, 2022 10:00 pm Thank you gents.
Insulating is an issue, it’s a 1920s brick built detached in an exposed location, to do it properly would probably take me close to a full rebuild budget wise. I can do stuff that will help either way as there is land for ground source and outbuildings for more solar.
I went room by room and wrote a list of points to address I have been around the house about three times over the past 6 years and there is a marked change in the interior environment (massive understatement). Did not cost that much, maybe £1,000 all in. The list is handy as focus point and memory assist.
The house is a 80's Barrett build extended three times. There is a lot of experience on here I'm sure you'll do well!
19.7kW PV SE, VI, HM, EN & DW
Ripple 7kW WT & Gen to date 19MWh
42kWh LFPO4 storage
95kWh Heater storage
12kWh 210ltr HWT.
73kWh HI5
Deep insulation, air leak ct'd home
Zoned GCH & Hive 2
WBSx2
Low energy bulbs
Veg patches & fruit trees
Ripple 7kW WT & Gen to date 19MWh
42kWh LFPO4 storage
95kWh Heater storage
12kWh 210ltr HWT.
73kWh HI5
Deep insulation, air leak ct'd home
Zoned GCH & Hive 2
WBSx2
Low energy bulbs
Veg patches & fruit trees
-
- Posts: 971
- Joined: Tue Jun 01, 2021 12:35 pm
Re: Hello from Somerset
Hi Jinx, hello from me in South Somerset.
Re: Hello from Somerset
Hi,
Before looking at energy input you need to get a grip on losses. Insulate and Insulate is not just glib it is the way forward and people think it is very expensive when often it is not particularly if done on a DIY basis. You do not say how much insulation and draught proofing you are starting with or what heat input you have so clearly cant advise.
Before looking at energy input you need to get a grip on losses. Insulate and Insulate is not just glib it is the way forward and people think it is very expensive when often it is not particularly if done on a DIY basis. You do not say how much insulation and draught proofing you are starting with or what heat input you have so clearly cant advise.
-
- Posts: 1873
- Joined: Thu Sep 09, 2021 3:42 pm
- Location: North East Dorset
Re: Hello from Somerset
Welcome. We're not far from Somerset, just in the little bit of Dorset that pokes up between Somerset and Wiltshire.
Agree with the above about losses. We had the advantage of building a new house several years ago, and chose to pretty much follow the Passivhaus methodology, but without spending the substantial premium for accreditation. Very pleased we did, as our house needs very little heating, all down to being pretty airtight, having good levels of insulation and being designed to remove thermal bridges in the structure to eliminate cool spots inside. Best bit is, I think, the airtightness, together with the heat recovery ventilation. Absolutely transformed the air quality in the house. Even now, years later, I am still very impressed with having clean and dry air in the house, and very little dust anywhere.
Agree with the above about losses. We had the advantage of building a new house several years ago, and chose to pretty much follow the Passivhaus methodology, but without spending the substantial premium for accreditation. Very pleased we did, as our house needs very little heating, all down to being pretty airtight, having good levels of insulation and being designed to remove thermal bridges in the structure to eliminate cool spots inside. Best bit is, I think, the airtightness, together with the heat recovery ventilation. Absolutely transformed the air quality in the house. Even now, years later, I am still very impressed with having clean and dry air in the house, and very little dust anywhere.
25 off 250W Perlight solar panels, installed 2014, with a 6kW PowerOne inverter, about 6,000kWh/year generated
6 off Pylontech US3000C batteries, with a Sofar ME3000SP inverter
6 off Pylontech US3000C batteries, with a Sofar ME3000SP inverter
-
- Posts: 662
- Joined: Mon Mar 21, 2022 7:37 pm
Re: Hello from Somerset
Dust and wood burning seem to be inextricably linked.
Morso S11
FIT
16 Sharp PV panels facing WSW 4kW
Solarmax 4200S inverter
Non FIT
3 Canadian solar DC coupled 1.75kW facing SSE
Storage
Growatt SPA3000TL BL inverter ac coupled
Growatt GBLI6532 6.5kWh lithium phosphate battery
FIT
16 Sharp PV panels facing WSW 4kW
Solarmax 4200S inverter
Non FIT
3 Canadian solar DC coupled 1.75kW facing SSE
Storage
Growatt SPA3000TL BL inverter ac coupled
Growatt GBLI6532 6.5kWh lithium phosphate battery